Instructions for using spiral drilling rig

Precautions for using a spiral drilling rig As a commonly used engineering machinery equipment, the following should be noted during use: preparation before construction, familiarity with the geological conditions of the site, and the development of a reasonable construction plan. Check whether the various components of the spiral drilling rig are intact, such as drill rods, drill bits, power systems, etc. Operators are required to undergo professional training and possess corresponding operational skills and knowledge. Strictly follow the operating procedures and do not operate in violation of regulations. During the drilling process, pay attention to controlling the drilling speed to avoid being too fast or too slow, so as not to affect the drilling quality and equipment life. Pay attention to the verticality of the drill rod, adjust it in a timely manner, and ensure that the borehole is vertical. Regular maintenance and upkeep of the spiral drilling rig, replacing worn parts. Keep the equipment clean and prevent debris from entering critical areas. Set up warning signs on the construction site for safety protection to prevent unrelated personnel from entering. Operators should wear protective equipment such as safety helmets and safety shoes. In short, when using a spiral drilling rig, it is necessary to strictly comply with relevant regulations and precautions to ensure construction safety and engineering quality.

Instructions for using spiral drilling rig

Spiral drilling rig is a widely used mechanical equipment in engineering construction. Here is a detailed introduction to its usage:

Firstly, it is essential to conduct a comprehensive equipment inspection before using a spiral drilling rig. Including but not limited to checking whether the drill bit is intact, whether the drill rod connection is stable, and whether the hydraulic system is normal.

When starting the drilling rig, follow the correct operating procedures. Start the engine first, wait for it to preheat and reach normal operating temperature, then gradually operate the hydraulic control lever to slowly enter the working state of the drilling rig.

During the drilling process, the drilling speed and pressure should be adjusted reasonably according to the geological conditions. When encountering hard formations, the drilling speed should be appropriately reduced to avoid damaging the equipment.

Meanwhile, it is important to maintain the vertical position of the drill rod to ensure the quality and accuracy of the drilling.

After the construction is completed, the engine should be turned off in a timely manner, and the equipment should be cleaned, maintained, and stored to prepare for the next use.

In short, the correct use and proper maintenance of spiral drilling machines can improve construction efficiency and ensure project quality.